Water Gravity Bong

Materials

-Small Bucket
-Knife/Exacto Knife
-Bottle
-Foil
-Safety Pin

Instructions to make it

First, fill the small bucket up with water.

Second, remove the cap of the bottle and cut the bottom off about two inches up from the bottom.

Next, take the foil and mold it into a bowl connected to the mouth piece of the bottle so it's pretty snug. You want it to go into the mouth piece just a little. Then poke holes with the safety pin that are close together where it dips into the mouth piece but you don't want to make big holes. (We're going for air tight here, but remember your going to have to remove this at some point) This is going to be your bowl.

Instructions to smoke

First, place the tobacco in the bowl.

Second, submerge the bottle vertically till it almost reaches the cap.

Then, light the bowl and slowly lift the bottle out of the water till there's about an inch submerged still.

Finally, remove the foil/bowl. Put your mouth on the mouth piece and inhale and push the bottle down.