Soda Can Pipe

Materials

-Soda can
-Safety pin
-Pen

Instructions to make it

First, wash out the can unless you want it to taste like soda. Choose a place where you want the bowl to be on the side of the can near the bottom. Use your thumbs to make an indention at that point till it looks like it has a downward curved surface. Also, note where the opening for the mouth piece is because you want it to be easy to access. I recommend having it directed to the side with the bowl.

Next, using the safety pin poke a bunch of holes at the deepest point of the indention till it looks like a screen almost. Try not to connect any of the holes so that way it is harder for ash to get through.

Then your going to make a carb where you think it would be easy for you to hold somewhere near the bottom of the can. Poke one hole with the safety pen and try to wiggle it around to make the hole bigger then use the pen to make it bigger if necessary. If you hold the can with the mouth piece (lid) towards you and the bowl facing up, I put it on the left side vertically aligned with the bowl.